ACCTEK / HomePage / News / Company news

Summary of 6 common laser processes
Summary of 6 common laser processes

Laser marking is one of the biggest application fields of laser machining.Laser marking is a marking method which USES a high energy density laser to illuminate the workpiece locally, make the surface material vaporize or produce a chemical reaction o ...

Instructions for the use and installation of laser tubes
Instructions for the use and installation of laser tubes

1) The laser tube is made of glass and is fragile.Avoid local stress during installation and use. 2) During adjustment, the laser support point or the laser orientation is rotated to achieve the best output effect, and then the laser is fixed. ...

Main parts and installation process of ACCTEK CO2 Laser machine
Main parts and installation process of ACCTEK CO2 Laser machine

Main components 1. Laser tube 2. Carbon dioxide laser 3. Laser power supply 4.Control panel 5. Flat table 6. Optical circuit system ...

Summary and analysis of laser technology
Summary and analysis of laser technology

Laser cutting technology has always been favored with high cutting precision and high efficiency. Laser cutting of thin plate has a short processing cycle and can save the cost of mold opening to a large extent to replace stamping.The application of l ...

Common fault of laser cutting machine and its solution
Common fault of laser cutting machine and its solution

Thermal cutting technique, except in a few cases can start from the edge of the board, generally in the board through a small hole.Previously, in the laser stamping compound machine, a punch was used to punch out a hole, and then a laser was used to s ...

Summary and analysis of laser technology!
Summary and analysis of laser technology!

Lasers are called "stimulated emission amplification".When excited by light or electricity, electrons in an atom absorb photoelectric energy and go from a lower energy level to a higher energy level, and then fall back to a lower energy level and rele ...

How to select cutting head by aperture and the influence of laser head on cutting
How to select cutting head by aperture and the influence of laser head on cutting

Impact cutting part, cutting gas jet, resulting in uneven gas volume, so cutting part is more likely to melt on one side, the other side does not have this phenomenon, in the cutting of the plate less than 3 mm, it has a small impact, in the cutting o ...

Working principle and cutting technology classification of laser cutting machine
Working principle and cutting technology classification of laser cutting machine

Laser cutting machine is a laser emitted from the laser, through the optical path system, focused into a high power density laser beam.The laser beam hits the surface of the workpiece to reach the melting or boiling point, and high-pressure gas coaxia ...

Get a Free Quote Now!