Acctek / HomePage / News / Q&A
How to adjust the laser to the center of nozzle
Updatetime: 2021-09-07 09:41 View:
Prepare :Scotch Tape , Allen Key


 
Principle : The left side of the figure is where the laser head is adjusted, and the right figure is the corresponding cross-sectional view. The laser head adjusts the center of the light to move diagonally. Adjust A and B clockwise through the inner hexagonal wrench, and the laser center point will move away from the wrench; for the same reason, adjust A and B counterclockwise, and the laser The center point will move to the side close to the wrench.
 


Procedures :Stick a piece of scotch tape on the nozzle ,set 10%-15% power in the software ,then press Pluse/Laser ,check whether the laser hole is in center of nozzle.If not in center ,please adjust it to center.
  


Tips:Here is some common adjustment.


  • Relevant tags:  
  • Original site:   https://www.acctekgroup.com/Q_A/How_to_adjust_the_laser_to_the_center_of_nozzle_4867.html

Get a Free Quote Now!

Jinan AccTek Machinery

Headquarters: 3-1007, Minghu Plaza, No. 777 Minghu West Street,Jinan City / Branch:  A3-4-905, Hanyu Jingu, High-tech Zone, Jinan City

Factory:  No. 3 Zone A, Lunzhen Industrial Zone,Yucheng City , Shandong Province( Postal code 251200)


Copyright © Jinan AccTek Machinery Co.,Ltd Power by DedeCms